Well thanks to all of you that have contributed on this board and my doing my homework, my first PCB run was near perfect! Using the Masters CNC Baron trammed to .0005 according to Pro-Tram, I was able to make these cuts on the first try. Smallest cut is .4304mm using a .1mm 20 degree V-bit, depth was set to .038 and it cut it right to the bone. I will try to get a better picture but wanted to show what this machine can do. And special thanks to Omar at CNC Masters who is always there to answer my questions!
I had to cut out most of the picture for legal reasons - the entire circuit is 24 x 25 mm this is just one little corner:
Image3.jpg
I had to cut out most of the picture for legal reasons - the entire circuit is 24 x 25 mm this is just one little corner:
Image3.jpg