2.5 D question

Trying to route outside the lines. I have tried about everything I can think of in profiling. I am a beginner with Madcam trying the software. I want to route these shapes and have them fitted so they can be routed from a piece of MDF that is sufficient size for these parts. I prefer to create the toolpath so it goes around the parts and not necessarily route one piece at a time. I am using a 3 axis gantry router table. My parts are routed from 3/4 MDF

Thanks.

Attached Images

• outside_924.JPG‎ (89.6 KB)
• outside_924_2.JPG‎ (77.5 KB)