Folks,
What do you guys have in your Mach3 settings for motor tuning/acceleration values for servo edition. Mine came with 14 in/s and it seemed to be too slow for short distance travels as rapids never get achieved. Bumping over 30 makes a bit of a jolt when the table moves and I am also concerned about the preloaded bearings. So what would you say optimum value is?
What do you guys have in your Mach3 settings for motor tuning/acceleration values for servo edition. Mine came with 14 in/s and it seemed to be too slow for short distance travels as rapids never get achieved. Bumping over 30 makes a bit of a jolt when the table moves and I am also concerned about the preloaded bearings. So what would you say optimum value is?