I have a factory Tree Journeyman 325 that I am pondering doing a retrofit to. Right now everything is stock and is working fine, but the controller is a pain to use sometimes, and I would like to get some newer stuff in there so I don't have to worry about expensive break downs later on. Anyway, it has Baldor servos on all 3 axes. I don't have the exact specs on the servos right now but I know they are fairly big and have 500line encoders. Up to this point all the retrofitting stuff I have looked into has been for smaller stuff. Who makes a good servo drives for larger servos? Where would one go about getting them? I just want to start looking to figure out when it would be feasible to do this.
↧