Hi,
attached is a CNC file which does a very simple turning operation.
The billet goes from Z=0 to -20mm
The turning operation from Z=0 to Z-10 mm
When the turning is finished, the tool makes a couple of funny movements in X direction, near Z0.
There is nothing to cut, it just moves the tool through the air.
During these sensless movements the Z position looks to depend on the tool tip radius.
Could you please look at this since it extends cutting times without doing anything.
Thank you
Harry
attached is a CNC file which does a very simple turning operation.
The billet goes from Z=0 to -20mm
The turning operation from Z=0 to Z-10 mm
When the turning is finished, the tool makes a couple of funny movements in X direction, near Z0.
There is nothing to cut, it just moves the tool through the air.
During these sensless movements the Z position looks to depend on the tool tip radius.
Could you please look at this since it extends cutting times without doing anything.
Thank you
Harry