Dear CncZone members!
I just recently replaced a ASUS P7M55 LE motherboard with a new ASUS P8Z77-V motherboard and I replaced also the Harddisks with WD Enterprise Edition 500 GB Harddisks. The RAID controller is a Promise FastTrak TX2300 and the RAID Array is a RAID 1 (Mirrored) Array.
I tested the new motherboard thoroughly before replacing the old motherboard. The Windows 7 64-bit Operating System worked normally.
I took the motherboard together with a Intel i3 3,3 GHz processor and the Hard Disks to the place where it is being used for CNC Machining yesterday. Today the fellow who run the CNC Machines and the computer told me, that he wasn't able to install SURCAM v 5.1 using that computer.
I wonder, what might be the problem? The fellow is going to send me a photo that describes what the error message is, and then I'll know more about, what might have caused the problem, that he wasn't able to install Surfcam v 5.1.
Looking forward to a prompt answer to my dilemma
Smyans
I just recently replaced a ASUS P7M55 LE motherboard with a new ASUS P8Z77-V motherboard and I replaced also the Harddisks with WD Enterprise Edition 500 GB Harddisks. The RAID controller is a Promise FastTrak TX2300 and the RAID Array is a RAID 1 (Mirrored) Array.
I tested the new motherboard thoroughly before replacing the old motherboard. The Windows 7 64-bit Operating System worked normally.
I took the motherboard together with a Intel i3 3,3 GHz processor and the Hard Disks to the place where it is being used for CNC Machining yesterday. Today the fellow who run the CNC Machines and the computer told me, that he wasn't able to install SURCAM v 5.1 using that computer.
I wonder, what might be the problem? The fellow is going to send me a photo that describes what the error message is, and then I'll know more about, what might have caused the problem, that he wasn't able to install Surfcam v 5.1.
Looking forward to a prompt answer to my dilemma
Smyans