I thought I'd post this in its own thread just in case there are any suggestions or comments. I am sure there are plenty of tricks and techniques out there so I am probably reinventing the wheel here, but I hadn't seen it yet so I thought I'd share!
I normally would mill out a separate fixture to hold a piece to be flipped. I started thinking that there had to be a way to do this without going through the multi-step hassle. Here is what I came up with.......
Results:
![]()
Cheers!
Brian
:cheers:
I normally would mill out a separate fixture to hold a piece to be flipped. I started thinking that there had to be a way to do this without going through the multi-step hassle. Here is what I came up with.......
Results:
Cheers!
Brian
:cheers: