Hey Guys,
Had an encoder fail a while back on the X axis and got that repaired by Oracle Encoder service. They did a great job and the machine was up and running. Now this Monday the Y axis failed. When I start up I don't get any error messages on the control, it just won't do the reference. The x references, the control charges and nothing happens. It just is stuck where the Y should be referencing. How do I trouble shoot this? If I have voltage at the motor does that mean it's the motor? If I don't have voltage at the motor is it the control board? Thanks. Dennis
Had an encoder fail a while back on the X axis and got that repaired by Oracle Encoder service. They did a great job and the machine was up and running. Now this Monday the Y axis failed. When I start up I don't get any error messages on the control, it just won't do the reference. The x references, the control charges and nothing happens. It just is stuck where the Y should be referencing. How do I trouble shoot this? If I have voltage at the motor does that mean it's the motor? If I don't have voltage at the motor is it the control board? Thanks. Dennis