This concerns Cubify Design.
Does anyone know if its possible to snap a new sketch to points on, for example, a previously extruded sketch?
What I am meaning is in SolidWorks I can have say a box that was previously extruded and now I want to sketch on a surface so I can extrude/cut a further feature. I can move the cursor over the mid point of the edge of the extruded cube and it will then snap to that point or I can move to a centre of one side then centre of the perpendicular side and then when I move towards the centre of the face I get two guide lines appear and I can snap to it.
Maybe not explaining very well but when I get home I will make a quick video of what I mean.
Hood
Does anyone know if its possible to snap a new sketch to points on, for example, a previously extruded sketch?
What I am meaning is in SolidWorks I can have say a box that was previously extruded and now I want to sketch on a surface so I can extrude/cut a further feature. I can move the cursor over the mid point of the edge of the extruded cube and it will then snap to that point or I can move to a centre of one side then centre of the perpendicular side and then when I move towards the centre of the face I get two guide lines appear and I can snap to it.
Maybe not explaining very well but when I get home I will make a quick video of what I mean.
Hood