I have a 98-z machine that I don't use very often. It was working fine(intermittent communication problem on and off for years). The machine sat for about six months. It was plugged into a power strip that was turned off. Other parts of the building encountered power problems during the time, and an outside transformer was replaced. Now when I initialize it does not connect to the table. The red and green turn on and go out but no connection. Its the table. I used a different computer and cables. I also connected to and old parallel printer and it worked. I have tried resetting comm settings. Its the table. Does anybody have any info on bench testing the control box? I have opened it up. nothing looks burnt or discolored. The fuse is good.
Any ideas would be appreciated.
Thank you in advance.
Mike
Any ideas would be appreciated.
Thank you in advance.
Mike