Hello everyone,
So as the title says I am experiencing overflow/underflow errors on any axis I try to move. Nothing moves at all, even during the homing sequence. I replaced and updated the motherboard and software in a hope that it was a bug there (plus the machine would just lock up (even mid cut) from time to time and was due for an upgrade), but no joy.
I have been able to move the axis with the spindle off if I remove the e-stop relay, which is what led me to believe it was a computer bug before. I replaced the relay unit as well, but still no effect.
Other than that, I have yet to find anything wrong with this machine.
Any suggestions?
So as the title says I am experiencing overflow/underflow errors on any axis I try to move. Nothing moves at all, even during the homing sequence. I replaced and updated the motherboard and software in a hope that it was a bug there (plus the machine would just lock up (even mid cut) from time to time and was due for an upgrade), but no joy.
I have been able to move the axis with the spindle off if I remove the e-stop relay, which is what led me to believe it was a computer bug before. I replaced the relay unit as well, but still no effect.
Other than that, I have yet to find anything wrong with this machine.
Any suggestions?