Hi there,
I am trying to create a surface, can someone help me achieve this?
With "Surface-Net", I was able to create a surface, but this surface doesn't have the contour I need.
I tried a few different methods but was unsuccessful and "Surface-Net" was closest I got.
In photo #3, the surface doesn't follow the cross rib lines and off the contour. How do I make it
follow the lines?
"Surface-Swept" sounds promising, but I just couldn't figure out how to use it.
Please see the attached photos if interested.
Thank you so much in advance,
KenSURFACE01.jpg
SURFACE02.jpg
SURFACE03.jpg
I am trying to create a surface, can someone help me achieve this?
With "Surface-Net", I was able to create a surface, but this surface doesn't have the contour I need.
I tried a few different methods but was unsuccessful and "Surface-Net" was closest I got.
In photo #3, the surface doesn't follow the cross rib lines and off the contour. How do I make it
follow the lines?
"Surface-Swept" sounds promising, but I just couldn't figure out how to use it.
Please see the attached photos if interested.
Thank you so much in advance,
KenSURFACE01.jpg
SURFACE02.jpg
SURFACE03.jpg