I was cutting a VW logo as practice and it was not bad but on the final pass around the outside it cut it way off. SO I cut it again and same thing even worse. So I figured I'd cut some circles to see, they cut fine. I cut 3 circles inside one another at a very small depth. But I measured them and they are fine.
Why would it not cut the logo right but the circles fine??
Even on the last VW cut in MDF at a very shallow depth it was off slightly at the top right and bottom left areas, as the width doesn't match.
Any ideas??
Thanks.
Why would it not cut the logo right but the circles fine??
Even on the last VW cut in MDF at a very shallow depth it was off slightly at the top right and bottom left areas, as the width doesn't match.
Any ideas??
Thanks.