I recently rebuilt a used Bosch 1617 with new bearings and brushes while installing a SuperPID. I have everything back together, but when I wire it up and plug it in, the breaker trips. This is the Bosch model without the factory speed control, so aside from replacing the brushes, I haven't altered the wiring. I've tried every permutation without any luck and am really bewildered. I've tested the switch and power cord and both are fine.
Here's a picture of what I remember to be the correct wiring arrangement : any help would be greatly appreciated.
photo (28).jpg
Here's a picture of what I remember to be the correct wiring arrangement : any help would be greatly appreciated.
photo (28).jpg