Hello,
My EZTRAK stopped in the middle of a heavy cut after hours of working fine. I was cutting some AL/BRONZE at a feed of 3.0" with a speed of 700rpms, and a width cut of 5" with a fly cutter. I am very new to AL/BRONZE, but didn't have this issue earlier this week. The machine has stopped before, and I've tried to let it cool down (sensors) and do a manual restart (red button outside of enclosure) but to no avail. Book said there is another switch to the right of the relay on the electrical panel but I cannot find it anywhere. Machine won't home, but it boots up. SO it must be the spindle. The oil reservoir is half full, but i'm going to add some more anyway. I don't think that's the issue though.
Small one man shop that needs your help!
Thanks,
karlwho
My EZTRAK stopped in the middle of a heavy cut after hours of working fine. I was cutting some AL/BRONZE at a feed of 3.0" with a speed of 700rpms, and a width cut of 5" with a fly cutter. I am very new to AL/BRONZE, but didn't have this issue earlier this week. The machine has stopped before, and I've tried to let it cool down (sensors) and do a manual restart (red button outside of enclosure) but to no avail. Book said there is another switch to the right of the relay on the electrical panel but I cannot find it anywhere. Machine won't home, but it boots up. SO it must be the spindle. The oil reservoir is half full, but i'm going to add some more anyway. I don't think that's the issue though.
Small one man shop that needs your help!
Thanks,
karlwho