I am looking to have two of these produced.
The holes are all the way through and .036" (+- 0.0005) (#64 drill).
Holes are spaced 0.986" (+- 0.003) apart
Holes are 0.300" (+- 0.010) from the long side and the first hole is 0.800 (+- 0.010)from the short side.
I am aware that the holes are not perfectly spaced on the length.
Each item:
Length: 6" (+- 0.125)
Width: 1"
Thickness: 0.375 (3/8)
This should be readily available sizes that just need to be cut to the right length, so it's just drilling holes in the right position.
Material:
Aluminum would be preferred, but teflon, deldrin or ptfe would also be acceptable.
Shipping would be to Pasadena, California
Side wire.jpg
Top.jpg
The holes are all the way through and .036" (+- 0.0005) (#64 drill).
Holes are spaced 0.986" (+- 0.003) apart
Holes are 0.300" (+- 0.010) from the long side and the first hole is 0.800 (+- 0.010)from the short side.
I am aware that the holes are not perfectly spaced on the length.
Each item:
Length: 6" (+- 0.125)
Width: 1"
Thickness: 0.375 (3/8)
This should be readily available sizes that just need to be cut to the right length, so it's just drilling holes in the right position.
Material:
Aluminum would be preferred, but teflon, deldrin or ptfe would also be acceptable.
Shipping would be to Pasadena, California
Side wire.jpg
Top.jpg