I have a Takisawa Drill tap center equipped with Fanuc OMC and Tool turret with NSK drive.
In the morning whenever I am trying to on this machine it's tool turret rotate and vibrate without any command given to tool turret, even it's rotate no safe zone area and It's broke tool pockets couple of times.
I have checked limit switches & sensors but no success.
As donot have it's electrical circuit diagram, It is quite difficult to diag. this problem.
Kindly somebody help me out from this problem.
In the morning whenever I am trying to on this machine it's tool turret rotate and vibrate without any command given to tool turret, even it's rotate no safe zone area and It's broke tool pockets couple of times.
I have checked limit switches & sensors but no success.
As donot have it's electrical circuit diagram, It is quite difficult to diag. this problem.
Kindly somebody help me out from this problem.