We have a bridgeport tc-30 with dx-32. we are having a problem with the tlo and the z axis. in the tool tables it is showing our tools to be 325" long. if w try to change it to a reasonable number, say 6 inches, the tool length changes but the z axis abs changes to 325 and the machine faults with an error saying z axis was commanded to move too far. the machine runs with those big tlo numbers untill we need to do a move with the 4th axis. we have a double table to extend the x axis length that has been labeled c axis. the program runs until the c axis is commanded t o move the the z axis goes back to 325" the machine faults out with z axis commanded to move too far. when the fault is cleared z axis position goes back to 0
↧