I have two Fanuc O controlled machines, one is a mill and other is a lathe.
On the mill i can download the parameters to my laptop in edit mode but i can not download the diagnostics. Tried setting PWE to 1 and 0 with EM stop on and off , tried it in edit mode and MDI, not sure what to do with that.
On my lathe i recently had a power surge and after powering machine back up i now have a 910 low memory parity alarm. I do have a copy of the paramters but i dont have a back up of the diagnostics. Im afraid to clear the memory before i have the diagnostics backed up. The machine powers up fine and everything looks normal until i push edit and it will then give the 910 alarm. I can hand write the diagnostics down but it looks like there are hundreds of diagnostics to set. That would be a test of my sanity. I cant access edit mode to download parameters or diagnostics. Do the diagnostics have to be set for the machine to run properly?
On the mill i can download the parameters to my laptop in edit mode but i can not download the diagnostics. Tried setting PWE to 1 and 0 with EM stop on and off , tried it in edit mode and MDI, not sure what to do with that.
On my lathe i recently had a power surge and after powering machine back up i now have a 910 low memory parity alarm. I do have a copy of the paramters but i dont have a back up of the diagnostics. Im afraid to clear the memory before i have the diagnostics backed up. The machine powers up fine and everything looks normal until i push edit and it will then give the 910 alarm. I can hand write the diagnostics down but it looks like there are hundreds of diagnostics to set. That would be a test of my sanity. I cant access edit mode to download parameters or diagnostics. Do the diagnostics have to be set for the machine to run properly?