hi
fanuc 16-tta, software version 103-20, macro pcb is onboard
manual says, that macroexecuter is a standart option, but when I enter corresponding option, system hangs up and leds on main cpu and sub-cpu shows "waiting for servo sustem ready"
this fanuc has come without parameters, I enetered parameters from similar swiss machine, but there was software 103-19
any suggestions?
fanuc 16-tta, software version 103-20, macro pcb is onboard
manual says, that macroexecuter is a standart option, but when I enter corresponding option, system hangs up and leds on main cpu and sub-cpu shows "waiting for servo sustem ready"
this fanuc has come without parameters, I enetered parameters from similar swiss machine, but there was software 103-19
any suggestions?