I have an Central Machinery lathe I purchased new in 2003'. Recently I was moving it around in my shop and I tipped it over onto it's side. The electrical panel was crushed as were all of the components inside. I have located all of the replacement part except for the transformer.
What I need help with is the wiring. I have the owners manual however it is very poor and does not show the placement for each of the wires.
I am hoping someone out there has this very same lathe and could send some photos of the inside of the electrical panel. Any help would be greatly appreciated! My contact info is: jfields@fleetsaleswest.com Jason Fields 32710 NE Lesley Rd Newberg, Oregon 97132
503-476-4123 thanks so much!
What I need help with is the wiring. I have the owners manual however it is very poor and does not show the placement for each of the wires.
I am hoping someone out there has this very same lathe and could send some photos of the inside of the electrical panel. Any help would be greatly appreciated! My contact info is: jfields@fleetsaleswest.com Jason Fields 32710 NE Lesley Rd Newberg, Oregon 97132
503-476-4123 thanks so much!