I need to slow down my cut speed on thinner materials (to stop table vibration). I've got a Hypertherm Powermax 1250 but it's smallest nozzles are 40 amp.
The manual says the current can go as low as 25 amp so I'm looking for a torch that can take advantage of this lower current. How I interface this torch is another matter.
Does anyone have any experience with a torch that goes as low as 25 amp.
Cheers,
Keith.
The manual says the current can go as low as 25 amp so I'm looking for a torch that can take advantage of this lower current. How I interface this torch is another matter.
Does anyone have any experience with a torch that goes as low as 25 amp.
Cheers,
Keith.