image.jpgimage.jpgWimage.jpg
Hi all,
Been on the forum a while now with intentions of building a mill and I have finally got started.
This is my first post so hello.
Here is a picture off my z axis colum, please can I have some constructive criticism. A comment that someone made to me was that the ball screw is going to be behind the slides and it should ideally be in the centre of the rails. Is this going to make a big effect? The colum is going to be mounted to a cast iron surface table I was given that I had to skim and grind.
Thanks in advanced for your help.
Matt.
Hi all,
Been on the forum a while now with intentions of building a mill and I have finally got started.
This is my first post so hello.
Here is a picture off my z axis colum, please can I have some constructive criticism. A comment that someone made to me was that the ball screw is going to be behind the slides and it should ideally be in the centre of the rails. Is this going to make a big effect? The colum is going to be mounted to a cast iron surface table I was given that I had to skim and grind.
Thanks in advanced for your help.
Matt.