1/8" Aluminum flat parts needed.

Hello need (2) pieces of the front pattern .dxf file and (2) pieces of the rear pattern .dxf file.

The parts are made from 1/8" aluminum. Un-tempered is preferred but not required.

These can be machined, laser, waterjet, or plasma. Dimensional tolerance is +-.025"


*Bonus if you have a sheet/plate roller, and can roll a radius onto these parts, please let me know. This isn't required but if i can kill 2 birds with 1 stone might as well.

Please private message me your email address, contact info, and any more information you require along with a general quote.

Located in WA state.

Thanks,

Diye

Attached Images

• AEGIS RENDER.jpg‎ (20.5 KB)

Attached Files

• Front pattern.DXF‎ (142.8 KB)
• Rear pattern.DXF‎ (47.3 KB)