Simulation visibilities

Lately, when I simulate with SC7, the material removed during an operation is not displayed as removed until the operation completes. Previously, it would show an appropriate amount of material removed on each pass in the simulation. This has happened before and I figure that it is either caused by an errant mouse button press on my part or by SC randomly changing settings on its own. I tried changing visibility of the different features in various combinations without success and finally hit on this one:

SC7 Simulation Visibility Settings.PNG

Is this the setting most others use? Are any others having trouble with the visibility settings getting changed on their own?

Mike

Attached Images

• SC7 Simulation Visibility Settings.PNG‎ (13.1 KB)