Solved Johnford VMC-750 Machine Zero?

Before I finished typing this I found the answer, but I thought it may help someone else, There was a value in the X (Shift) on the work coordinates page.

I recently purchased a used Johnford VMC-750 with a Fanuc O-M control, this is my first time running the machine and I am having an issue setting zero on the corner of my work piece.

I set G54 to x0, y0 and ran G0 G54 x0 y0 in MDI, I thought it would go to machine zero, it did go to machine zero in Y but X went to the middle of the table.

Thanks,
Don