So, if I want to chamfer an outside edge of a part and do it in cam, how does that work on the machine? Do I set my tool height at the tip of the tool, and some how Mach knows how far down to run the tool and how far to offset it? Not sure how that whole chain works and how any of it knows how deep to set the tool....
(I Use SolidWorks and do model the chamfer there, HSM Express, and of course Mach3 on the Tormach)
TIA...
(I Use SolidWorks and do model the chamfer there, HSM Express, and of course Mach3 on the Tormach)
TIA...