Hello again everyone. Since no one has responded to my last post about a SaleCNC XJ1325 machine I thought maybe if I got specific on the parts I need more info on someone would be able to help.
I have switched over to Mach3 because of the endless issues I was having with their software and controller. I switched using a CENTIPEDE controller etc KSI Labs, LLC and Sergey has gone above and beyond helping me switch over the boards, even helping me reprogram my VFD to work properly and I am 90% of the way there.
The problem I am having is I'm definitely losing steps so I need to tune but the Chinese salesman knows almost nothing about the technical aspects of the components. He was able to give me the steps, at least he says they are the right ones, but beyond that they are no help. And when I ask about Step Pulse and Dir pulse they have no clue what I'm even asking.
So far what I know is I have:
X & Y steppers are 96.01536 (they called them pulses)
I have two motors on the Y
Both X&Y motors are 86BYGH450B-060-15J and are 1.8 deg pitch
The Z step is 160, 1.8 deg pitch same motor part number but ends at the B. Nothing I can find shows this part number with nothing after it but the motor shows it is 4.3A 0.55Ohms 6.0mH
Sergey at KSILabs modified my XML and it is working a little better than what I had but on the last thing I tried cutting the Z cuts kept getting progressively deeper and suddenly plunged down about halfway through the board.
Any help at all would be greatly appreciated. I've had this machine for 3 weeks now and haven't been able to successfully use it yet.
I uploaded my mach3 xml file and renamed it to pdf if anyone needed to look at that.
Any help would be much appreciated.
I have switched over to Mach3 because of the endless issues I was having with their software and controller. I switched using a CENTIPEDE controller etc KSI Labs, LLC and Sergey has gone above and beyond helping me switch over the boards, even helping me reprogram my VFD to work properly and I am 90% of the way there.
The problem I am having is I'm definitely losing steps so I need to tune but the Chinese salesman knows almost nothing about the technical aspects of the components. He was able to give me the steps, at least he says they are the right ones, but beyond that they are no help. And when I ask about Step Pulse and Dir pulse they have no clue what I'm even asking.
So far what I know is I have:
X & Y steppers are 96.01536 (they called them pulses)
I have two motors on the Y
Both X&Y motors are 86BYGH450B-060-15J and are 1.8 deg pitch
The Z step is 160, 1.8 deg pitch same motor part number but ends at the B. Nothing I can find shows this part number with nothing after it but the motor shows it is 4.3A 0.55Ohms 6.0mH
Sergey at KSILabs modified my XML and it is working a little better than what I had but on the last thing I tried cutting the Z cuts kept getting progressively deeper and suddenly plunged down about halfway through the board.
Any help at all would be greatly appreciated. I've had this machine for 3 weeks now and haven't been able to successfully use it yet.
I uploaded my mach3 xml file and renamed it to pdf if anyone needed to look at that.
Any help would be much appreciated.