Hi, everyone
New & inexperienced user of a multicam 3000 cnc, using to cut acrylic mostly but also dibond & mdf for jig making.
Looking forward to picking up tips & tricks.
Already have one issue, when cutting rectangles using the hand held control, it always cuts clockwise, leaving a fluffy edge on the panel instead of leaving it on the off cut piece, if I send a program across cutting anti clockwise I don't have this problem, can I change the cutter direction from the control pad?, any help would be appreciated .
New & inexperienced user of a multicam 3000 cnc, using to cut acrylic mostly but also dibond & mdf for jig making.
Looking forward to picking up tips & tricks.
Already have one issue, when cutting rectangles using the hand held control, it always cuts clockwise, leaving a fluffy edge on the panel instead of leaving it on the off cut piece, if I send a program across cutting anti clockwise I don't have this problem, can I change the cutter direction from the control pad?, any help would be appreciated .