Hi all,
I bought some Advance Motion Control (AMC) drivers :
Brushless BD15A8
Brushless 12A8E
Brushes B12A6D
I would like to connect them to Mach3 how do I do that? do I need other interface cards? Can that be resolved with logic chips dose someone have schematics of a circuit that does this I also would like to have the motor do lathe spindle/A-axis as shown on
Please help
I bought some Advance Motion Control (AMC) drivers :
Brushless BD15A8
Brushless 12A8E
Brushes B12A6D
I would like to connect them to Mach3 how do I do that? do I need other interface cards? Can that be resolved with logic chips dose someone have schematics of a circuit that does this I also would like to have the motor do lathe spindle/A-axis as shown on
Please help