[B]HURCO km5p not working servo boards lit up with code base current is blocked the codes probable cause is that machine is in E stop. I do not know of any stop button other than the one on the control . I checked the switch and even went onto the board and used jumper wires to bypass switch. I cycled the x y z limit switches on all 3 axis to make sure they were not stuck. Its been awhile since I used this mill. I have air pressure to the spindle tool changer 90 psi. I checked all the fuses on both sides servo drive side and the driver boards side. At a loss as to what the problem is. Any help with somebody that is familiar with this would be great. Thanks Ron
↧