2006 Doosan Lynx 220L with 2000 hours or 2004 Daewoo Puma 240L with 176 cutting hours. Both are priced around $40K. Which do I choose?
The smaller Lynx has had one service in 2007 and seems in good working condition and comes with loads of tooling. The Puma has been sitting for a few years and has some surface rust. This machine has had one turret crash that was repaired by the agents and seems in good condition.
How do I physically check for damaged boxways?
The smaller Lynx has had one service in 2007 and seems in good working condition and comes with loads of tooling. The Puma has been sitting for a few years and has some surface rust. This machine has had one turret crash that was repaired by the agents and seems in good condition.
How do I physically check for damaged boxways?