After homing and setting machine zero, absolute zero is set to whatever values is in the G54 offset and all is fine. If the machine is shut down and restarted, absolute is off from what it was. The reading is displaying a positive amount by the value in the g54 offset. Machine zero is reading the same but not absolute. Is there are parameter to help with this?
Currently parameter 10 is set at: 10010101. I tried it with 00010101 but the same result. Parameters 708-710 are set with all zeros.
Currently parameter 10 is set at: 10010101. I tried it with 00010101 but the same result. Parameters 708-710 are set with all zeros.