I am a new machinist who recently had my first crash, i don't know how else to put it but the part came out of the chuck and damaged part of the chuck. This was last friday 5/3/2013, and i had looked at the chuck, and jaws and found no series damage, a little bit of the ss i was cutting got stuck to a jaw, but it was still on center. Then today 5/7/2013 the chuck had release a second part and did some more damage. I am starting to think that the jaws or the scroll system inside the chuck might be bad. How would i know? Also where would a good place to buy jaws for a ten inch chuck?
↧