Hello,
I manufacture effect pedals for harmonica players that are housed in small cast aluminum enclosures. I currently drill holes for the controls, lights and switches using a drill press; but I am considering upgrading to a CNC machine. My products have holes on the top and the sides but if I could get a machine to do just the holes in the top of the enclosure that would be fine.
My products can be seen at LONE WOLF BLUES COMPANY
Where do I start? What type of machine should I look for?
Any advice is apreciated.
Sincerely,
Tickfawriver
I manufacture effect pedals for harmonica players that are housed in small cast aluminum enclosures. I currently drill holes for the controls, lights and switches using a drill press; but I am considering upgrading to a CNC machine. My products have holes on the top and the sides but if I could get a machine to do just the holes in the top of the enclosure that would be fine.
My products can be seen at LONE WOLF BLUES COMPANY
Where do I start? What type of machine should I look for?
Any advice is apreciated.
Sincerely,
Tickfawriver