I setup my mill , 3 axis , using linuxcnc step config program.
step time 10k
step space 10k
Dir hold 20k
Dir setup 20k
jitter 14300
motor step per rotation 400 , micro step 2 , 1 to 1 , 10 leadpitch , max vel 10 mac accel 30. When I test it and when I run short programs my x , y , z all only go 1/2 the distance.
I set 10" it only goes 5" , I set 2.5" it only goes 1.25" on and on and on. kl4030 , 425oz , c10 BOB . It works but it only goes 1/2 the distance. I have tried several combinations
for microstep and anything else that might fix the problem.But I have hit a wall.
If anybody has any ideas and or suggestions. I am all ears!
step time 10k
step space 10k
Dir hold 20k
Dir setup 20k
jitter 14300
motor step per rotation 400 , micro step 2 , 1 to 1 , 10 leadpitch , max vel 10 mac accel 30. When I test it and when I run short programs my x , y , z all only go 1/2 the distance.
I set 10" it only goes 5" , I set 2.5" it only goes 1.25" on and on and on. kl4030 , 425oz , c10 BOB . It works but it only goes 1/2 the distance. I have tried several combinations
for microstep and anything else that might fix the problem.But I have hit a wall.
If anybody has any ideas and or suggestions. I am all ears!