I finally got around to adding a proper user interface and a short user guide to my v-bit dovetail software. It is a kind of beta version but already pretty solid and can be used for practical dovetail g-code generation.
I would like to invite everybody who is interested in such stuff to
-->> download the software and try it out. <<--
I hope you will like it (although this is a demo version with mildly limited features). There is no real install, just unzip the files, read the guide and run the "Tailmaker.exe" file.
Please post general comments here (yes, positive and negative as well). You can PM specific questions.
If there is sufficient interest I will establish some licensing method and set up a web site to purchase the fully featured software version. In the meantime there are probably many projects you can do with the software as-is. Please post a picture of whatever you make!
I hope this post does not violate the rules of this forum but so far this is not advertising (yet).
![]()
I would like to invite everybody who is interested in such stuff to
-->> download the software and try it out. <<--
I hope you will like it (although this is a demo version with mildly limited features). There is no real install, just unzip the files, read the guide and run the "Tailmaker.exe" file.
Please post general comments here (yes, positive and negative as well). You can PM specific questions.
If there is sufficient interest I will establish some licensing method and set up a web site to purchase the fully featured software version. In the meantime there are probably many projects you can do with the software as-is. Please post a picture of whatever you make!
I hope this post does not violate the rules of this forum but so far this is not advertising (yet).
