Wiring a new CNC4PC C41 spindle PWM controller, to an ICON-MC60 motor controller, on a HF44991. The M3 and M4 commands get the spindle turning, in the same direction for either command, but a M5 doesn't stop the spindle. It slows considerably, but it is still turning. I have a 4 axis Xylotex for motion, and just passing the pins through it.
If I measure voltage across the analog output I get ~0.7VDC after the M5. I also expected that relay 1 would turn off, gone open, but it never does. It clicks a few times, but mainly remains closed.
It is in US mode.
Thanks,
Rod
If I measure voltage across the analog output I get ~0.7VDC after the M5. I also expected that relay 1 would turn off, gone open, but it never does. It clicks a few times, but mainly remains closed.
It is in US mode.
Thanks,
Rod