Newbie having a problem with a bar puller program. Running a Hyundai Hit250C w/ Fanuc oi-ta controller. Program attached. Read most of the posts about bar pullers and what to look for: door closed, not in single block, G98 IPM, etc.
What is happening is at line N70 the machine goes no further, the turret will not move the 1.25 distance and move down over the bar.
Can anyone give me some pointers what to look for? Would much appreciate any info to get this working.
Jerry
O0301
(PULL ROUTINE )
(Fanuc 0i-TA)
N10 G59 (OFFSETS X-13.65 Z-20.00 )
N20 T0909
N30 M05 (SPINDLE STOP)
N40 G00 X6.00 Z0.00
N50 M00
N60 G98 (IPM)
N70 G01 Z-1.25 F24
N80 X0.0
N90 M06 (CHUCK OPEN)
N100 G04 P5
N110
N120 G01 Z1.25
N130 M07 (CHUCK CLOSE)
N140 G04 P5
N150 G01 X4.0
N160 Z0.0
N170 G99 (IPR)
N180 M00
N190 G28 U0.0 W0.0
What is happening is at line N70 the machine goes no further, the turret will not move the 1.25 distance and move down over the bar.
Can anyone give me some pointers what to look for? Would much appreciate any info to get this working.
Jerry
O0301
(PULL ROUTINE )
(Fanuc 0i-TA)
N10 G59 (OFFSETS X-13.65 Z-20.00 )
N20 T0909
N30 M05 (SPINDLE STOP)
N40 G00 X6.00 Z0.00
N50 M00
N60 G98 (IPM)
N70 G01 Z-1.25 F24
N80 X0.0
N90 M06 (CHUCK OPEN)
N100 G04 P5
N110
N120 G01 Z1.25
N130 M07 (CHUCK CLOSE)
N140 G04 P5
N150 G01 X4.0
N160 Z0.0
N170 G99 (IPR)
N180 M00
N190 G28 U0.0 W0.0