I got this setup from McMaster in order to get chip clearance without needed to hold the air hose:
![]()
The base has a strong (25lb) magnet and 5 theaded 1/4NPT holes (plugs supplied). Ordered this and a nozzle kit, plus an assembly tool for snapping the pieces together. The single nozzle really blows hard, so I doubt I'll need any more.
Since my parts are typically one-offs with short machining times, I think air works as well as coolant most of the time.
The base has a strong (25lb) magnet and 5 theaded 1/4NPT holes (plugs supplied). Ordered this and a nozzle kit, plus an assembly tool for snapping the pieces together. The single nozzle really blows hard, so I doubt I'll need any more.
Since my parts are typically one-offs with short machining times, I think air works as well as coolant most of the time.