I'm putting a project together and have some early rough drafts for parts. The dimensions aren't set in stone but it's pretty indicative of the final product. The main things that might change are hole placements, particular threads, and minor changes to dimensions.
A quick description of the parts:
Deck: 316 Stainless, ~approximately 5/8th inch round plate with a small threaded post, drilled center hole, offset threaded hole and a lip. (more detail in the drawings obviously)
Cap: approximately 5/8th inch cap that will go over the deck, ~1mm thick wall ~2mm thick 'top' with the inside bored out, a hole in the top and a small ~1.5mm hole in the sidewall. Also 316 Stainless.
bushing: Delrin or nylon bushing (not material dependant, just has to act as an isolator and be able to be threaded) to go into the center hole of the deck. Relatively small and with a threaded center hole.
What I'm looking for is twofold.
I'd like to get a "prototype" cost for a small run of about 10 of each part and I'd like to get a rough estimate of cost on a larger order, say 300 of each part.
As I said above, this is not the final design, I'm trying to get a cost estimate so I know where to budget. The work isn't far off and when I get the final designs I will want to do at least 1 prototype phase followed by a ramping production run starting at around 300 of each part and increasing over time.
Thanks in advance.
Apparently I can't upload IDW files to this forum so if you would like to run a quote on this, please PM me or email at lance-ftw@outlook.com Thanks!
A quick description of the parts:
Deck: 316 Stainless, ~approximately 5/8th inch round plate with a small threaded post, drilled center hole, offset threaded hole and a lip. (more detail in the drawings obviously)
Cap: approximately 5/8th inch cap that will go over the deck, ~1mm thick wall ~2mm thick 'top' with the inside bored out, a hole in the top and a small ~1.5mm hole in the sidewall. Also 316 Stainless.
bushing: Delrin or nylon bushing (not material dependant, just has to act as an isolator and be able to be threaded) to go into the center hole of the deck. Relatively small and with a threaded center hole.
What I'm looking for is twofold.
I'd like to get a "prototype" cost for a small run of about 10 of each part and I'd like to get a rough estimate of cost on a larger order, say 300 of each part.
As I said above, this is not the final design, I'm trying to get a cost estimate so I know where to budget. The work isn't far off and when I get the final designs I will want to do at least 1 prototype phase followed by a ramping production run starting at around 300 of each part and increasing over time.
Thanks in advance.
Apparently I can't upload IDW files to this forum so if you would like to run a quote on this, please PM me or email at lance-ftw@outlook.com Thanks!