Hello-
I would like to have each of these 4 parts quoted in qty of 5, 10, and 20 each.
Material is aluminum
Tolerances are reasonable
I have models in Solidworks 2010
I hope this is enough to determine if you are interested
These two have been made from 1.5" hex aluminum. The one with the larger thread is 1 3/8" and the other is threaded with 1" thread. Coarse or fine thread would suffice as long as their mates have matching thread.
Threaded-top.JPG
The 2 mating parts are shown here. Made from 1.75" OD aluminum and they have matching internal threads. The outside profiles are the same for each, only the inner bores and threads are different.
threaded-bottom.JPG
Please post in this thread, or PM me with any questions.
I'm located in TX, USA.
I would like to have each of these 4 parts quoted in qty of 5, 10, and 20 each.
Material is aluminum
Tolerances are reasonable
I have models in Solidworks 2010
I hope this is enough to determine if you are interested
These two have been made from 1.5" hex aluminum. The one with the larger thread is 1 3/8" and the other is threaded with 1" thread. Coarse or fine thread would suffice as long as their mates have matching thread.
Threaded-top.JPG
The 2 mating parts are shown here. Made from 1.75" OD aluminum and they have matching internal threads. The outside profiles are the same for each, only the inner bores and threads are different.
threaded-bottom.JPG
Please post in this thread, or PM me with any questions.
I'm located in TX, USA.