I came across a series 1 boss 4 on craigslist and picked it up cheap enough that one atm withdraw covered it.
In order to get it home I had to split it into 2 runs to get it home in my tacoma.
It looks generally complete and in good shape but dirty and nasty and since its already mostly apart I want to finnish the job and also repaint it.
the only main components left assembled in the bottom end are the knee and column
top end was removed in one piece
So should I continue and remove the knee?
I am planning to pressure was and air dry the lower end components.
What about the top end. Its seems like it will be difficult to disassemble while its off and in one piece, should it go back on, before being torn down?
Any advice is appreciated.
In order to get it home I had to split it into 2 runs to get it home in my tacoma.
It looks generally complete and in good shape but dirty and nasty and since its already mostly apart I want to finnish the job and also repaint it.
the only main components left assembled in the bottom end are the knee and column
top end was removed in one piece
So should I continue and remove the knee?
I am planning to pressure was and air dry the lower end components.
What about the top end. Its seems like it will be difficult to disassemble while its off and in one piece, should it go back on, before being torn down?
Any advice is appreciated.