With the Tormach 770, when milling a pocket in steel or ss 304, using carbide, what would be the deepest
cuts with each pass?
assuming it was a 4 inch thick by 5 inches long and 3 inches wide.. The pocket would be 2 inches deep
and 2 inches long and 2 inches wide.
what would the g code be? are there any canned cycles in g code?
Thanks for any info you may share.
cuts with each pass?
assuming it was a 4 inch thick by 5 inches long and 3 inches wide.. The pocket would be 2 inches deep
and 2 inches long and 2 inches wide.
what would the g code be? are there any canned cycles in g code?
Thanks for any info you may share.