Need Help! Question on thread mill program

Help,

I have started running thread mills and have had very good results. My problem is when I try to run them on my big Matsurra I keep getting a invalid plane error when it gets to the helical interpolation. It is a Matsurra 2000 with a fanuc 11 control.

I generated the program with Vardex thread mill generator and they run perfect on my 3 other mills. Any advice would be greatly appreciated.

The program is something like this


O0001 (TMINRH CLIMB Operation.Cycles= 1)
(Tool cutting diameter = 0.516 inch - Fanuc 11M Controller.)
G90 G00 G57 X0 Y0
G43 H10 Z0 M3 S2664
G91 G00 X0 Y0 Z-1.0084
G01 G41 D60 X0.0329 Y-0.2796 Z0 F1.29
G91 G03 X0.2796 Y0.2796 Z0.0084 R0.2796 F1.29
G91 G03 X0 Y0 Z0.0909 I-0.3125 J0 F4.29
G91 G03 X-0.2796 Y0.2796 Z0.0084 R0.2796
G00 G40 X-0.0329 Y-0.2796 Z0
G90 G00 Z8.0000
M5
M30
%