ok, so I am making a bunch of 0.76" holes in some 0.25" 6061 plate, no biggie there sorta...
I got the spindle load meter,mostly because I thought it looked cool...
first whole, its in the green the whole time, so I figure my speeds & feeds are probably pretty decent...
but on some hole (all exactly the same as the first) the meter ius bouncing off the red... and the spindle sounds sad...
why?
what is different between holes?
I got the spindle load meter,mostly because I thought it looked cool...
first whole, its in the green the whole time, so I figure my speeds & feeds are probably pretty decent...
but on some hole (all exactly the same as the first) the meter ius bouncing off the red... and the spindle sounds sad...
why?
what is different between holes?