Hello again,
we have an Okuma LCC15 with osp 700L with no documentation at all. it just came from other plant and we have a problem right after power on - we can open the doors (auto.doors) with pushbutton from op.panel but cannot make any axis movement nor close the door. the signals from door limit switches we can see inside the controller and thats all. we definetely need an electrical drawing to see what is missing.
if You have the drawings - to borrow to scan or to sell or any other way to make it working - it would be very helpful to Us.
thanks.
we have an Okuma LCC15 with osp 700L with no documentation at all. it just came from other plant and we have a problem right after power on - we can open the doors (auto.doors) with pushbutton from op.panel but cannot make any axis movement nor close the door. the signals from door limit switches we can see inside the controller and thats all. we definetely need an electrical drawing to see what is missing.
if You have the drawings - to borrow to scan or to sell or any other way to make it working - it would be very helpful to Us.
thanks.