Hello all,
Attached is a scanned diagram from our HAAS milling machine manuals showing the G13 command, which is an incremental circular pocket milling command.
This G13 command does not exist on our newer Fanuc 16i-M controller for our horizontal boring mill.
Using the macro found here:
Circle Milling A Bolt Hole Pattern : Modern Machine Shop
I have been able to circular mill in a bolt hole pattern but in a single cut.
There must be a way to take multiple cuts as in this G13 haas cycle?
Any thoughts? Thank you in advance.
Attached is a scanned diagram from our HAAS milling machine manuals showing the G13 command, which is an incremental circular pocket milling command.
This G13 command does not exist on our newer Fanuc 16i-M controller for our horizontal boring mill.
Using the macro found here:
Circle Milling A Bolt Hole Pattern : Modern Machine Shop
I have been able to circular mill in a bolt hole pattern but in a single cut.
There must be a way to take multiple cuts as in this G13 haas cycle?
Any thoughts? Thank you in advance.