Is 120 IPM on X and Y a decent speed to calculate for?
I'd presume rapids could be higher until it starts missing steps but as max speed within the torque curve is that a good bet?
What about Z... I'm kind of thinking of using a higher torque/lower speed option on Z to compensate for the mass of hauling that around... does that make sense or do I use the same 120 IPM (or other suggested speeds)?
I'd presume rapids could be higher until it starts missing steps but as max speed within the torque curve is that a good bet?
What about Z... I'm kind of thinking of using a higher torque/lower speed option on Z to compensate for the mass of hauling that around... does that make sense or do I use the same 120 IPM (or other suggested speeds)?