Hi guys,
As a newbie i am not sure if this is the correct place to post, however -
I have got a Yang ML25a with fanuc OT controls.
This morning had to do a shift p cancel to get the machine to reference in X
having done this an re-probed tools i found that the machine is reading 20mm too large in X.
So have gone in mdi, pwe = 1 in diag/parameters paged down to 0508 which reads 400, the position shows X -20.076
Can any one tell me please what figure i should now enter inter parameter 0508 to correct this error.
big thanks for eading this post and any suggestions you may have.
atb
roe1223
As a newbie i am not sure if this is the correct place to post, however -
I have got a Yang ML25a with fanuc OT controls.
This morning had to do a shift p cancel to get the machine to reference in X
having done this an re-probed tools i found that the machine is reading 20mm too large in X.
So have gone in mdi, pwe = 1 in diag/parameters paged down to 0508 which reads 400, the position shows X -20.076
Can any one tell me please what figure i should now enter inter parameter 0508 to correct this error.
big thanks for eading this post and any suggestions you may have.
atb
roe1223